I - painfully - learned a few things today. First: put the adaptornut (the one for the water return pipe) back into the waterpump housing before you stick it on the engine and puts the radiator in front. Adaptornut cannot be moved one flat with house in situ. That sucks!
Second: check the treads on the waterpump housing before you put everything back together (again). When tightening the alloy thermostat housing the bolt kind of did not bite. and of course there is not any room for a nut under the housing. Going up in boltsize very shortly I believe.
Sunday, 14 October 2007
Subscribe to:
Post Comments (Atom)
1 comment:
Before fitting an oversize bolt try putting PTFE tape on the thread. PTFE tape is the stuff plumbers use to seal threads and will make the bolt slightly bigger.
Post a Comment